Yamaha mt09 ecu flash software#
Yamaha mt09 ecu flash code#

If your an old guy like me you will likely remember reports of audi cars getting into run away situations when they first went to fly by wire systems. You recycle the key and the system does a check and if all is good the bike runs like normal till the condition happens again. limp mode means the bike will idle but your throttle has no effect on the tps controlled by the computer. If the computer controlled one gets to far ahead of the one controlled by the cables the computer reads this as a possible run away situation and to be safe puts the bike in limp mode and displays SD-50 on the dash. The other the computer opens, this one is what determines how much throttle you actually get. There are 2 throttle position sensors on the bikeġ the throttle cables are connected to and is opened with your right wrist

Yamaha mt09 ecu flash software#

Also ftecu built limits into the fly by wire settings to prevent exactly the problem the op is having that were discovered shortly after the software was released for the fz09 in 2014.

This is why i asked what software was used, woolich and ftecu have sum checks im not sure about any of the freeware thats floating out there. I rode the bike all fall with not issues prior to the ECU flash. No answer from the company that flashed yet. After two minutes the same problem occured. So I replaced the entire cable harness on the bike which took me about 40h work time. The company whom flashed my ECU said that it might be connectors to the ECU that are faulty. Sometimes it has been 30 seconds between the errors and other times two hours. Then the bike works like normal for a random period of time. Then the bike wont start until i turn the ignition off and on again.

Yamaha mt09 ecu flash code#

According to haynes this is 'ECU malfunction, fault code may not be displayed - Engine will not run' due to 'ECU internal memory malfunction'. On random occasion the bike turns off with the error code SD_50. With this bike-side FTECU Data-Link Flashing Kit, you can adjust a wide variety of parameters and remove factory limitations put in place by Yamaha. Get the very same tools and technology used by factory race teams around the world. After the flash I'm experiencing some issues. FTECU Data-Link ECU Flashing Kit for Yamaha FZ-07 / MT-07 & YZF-R7. During the winter I sent of my ECU to get flashed.